Table of Contents
Advertisement
5700 STEP TOP ACC
Adapters
Figure 18.1
ARS
Cover
Reinstall 3 front
bricks back into
Figure 18.2
Figure 18.3
18
Ash Removel
Drawer
ARS
Channel
firebox
Cover
Plate
B. Access Cover Handle
Insert Access Cover Handle handle into slot of ARS Cover to
remove ARS Cover for cleaning ash out of firebox (Figure 18.4).
Figure 18.4
C.
Leg Kit and Ash Removal System (ARS)
Installation
NOTE:
The Ash Removal System, must be
installed first before installing the legs.
Included in Kit: ARS door assembly, ARS latch assembly, Ash
Removal Box, Ash Removal Drawer, ARS Channel, ARS Cover,
and fastener package.
Tools Required: 7/16 socket wrench, 9/16 socket wrench, 3/8
open end wrench, phillips screw driver, and hammer.
Begin installing the ARS System.
1. Remove leg mount brackets packaged inside of firebox
and set aside.
2. Remove the 3 bricks in the front most part of the firebox
(Figure 16.1 on page 16).
3. Lay appliance on its back on a protective pad or pallet
(Figure 16.2 on page 16).
4. Remove heat shield by loosening the four bolts using 3/8
open end wrench (Figure 16.2 on page 16).
5. Remove 8 nuts that hold the cover plate on using a 7/16
socket wrench; discard cover plate (Figure 16.2 on page
16).
CHECK GASKET!
•
Verify that the gasket is present and that the glossy
side is away from firebox bottom.
•
It is important that the gasket is put in correctly for
sealing capabilities.
7038-206F
Warning!
September 27, 2016
Advertisement
Table of Contents
