Change Light Bulbs; Motion Detector - Overview; Reset - Open/Close Travel Limit; Carriage Engage/Disengage - Genie POWERMAX 1200 3062 Operation And Maintenance Manual

CHANGE LIGHT BULBS

Observe all safety warning and precautions!
Improper light bulb removal or replacement
could result in Death or Serious Injury.
Disconnect power from opener before
beginning this task.
When replacing light cover, make sure wires are
not pinched or near moving parts.
1. Disconnect power to door opener.
owerhead light cover.
ove light bulb(s).
ce with maximum 100 Watt light bulb(s).
– Do NOT use light bulbs with greater than
100 Watt rating.
owerhead light cover.
2. Reconnect power to door opener.
Test light operation.
MOTION DETECTOR* - OVERVIEW
(Not available on all models)
Powerheads equipped with a motion detector
sensor provide additional security when
exiting or entering the garage area.
*This sensor works by detecting body heat. Range of detection may be
reduced when the temperature in the garage is close to body temperature.
NOTE: Detector positioning on the powerhead provides
for monitoring below the powerhead.
OPERATION
Detector sensor is always ON. There are NO user
controls or adjustments.
Lights automatically turn ON when a change is
detected and will turn OFF after 4 minutes of no
change.
Motion detector sensor will not turn OFF lighting
turned ON at the wall console .
Lighting turned ON at the wall console will remain
ON until wall console turns lighting OFF or opener
is used.
Motion Detector

RESET - OPEN/CLOSE TRAVEL LIMIT

Performing all ten (10) Limits/Force setting steps
(pages 6-7) erases previous Limits/Force settings.
NOTE: The opener will not close the door
automatically unless the Safe-T-Beam® System is
installed and Limits are programmed.
©2011 The Genie ompany
WARNING
SHUTTLE ENGAGE/DISENGAGE
Use Release Handle to manually connect or release
Shuttle from carriage and screw drive shaft.
N O T
I F D O IC E
O R B
E C O M
P U LL E S O
D O W B S T R
N O N U C TE
H A N D D
LE
PULL
TO ENGAGE SHUTTLE:
1. Pull DOWN on handle and let go.
2. Raise or lower door using remote or wall console.
FIG. 6-3 Shuttle Release
3/2011
TO RELEASE SHUTTLE:
1. Pull DOWN on handle and let go.
2. Raise or lower door manually.
DOOR
19