Corrective Maintenance; Changing Light Bulbs; Remote Battery Replacement - Genie POWERLIFT 900 Operation & Maintenance Manual

ROUTINE YEARLY
Lubricate the drive screw:
Wipe off old grease using a lint-free cloth.
Apply a light coating of silicon based grease
(For best results, use Genie® GLU-R).

CORRECTIVE MAINTENANCE

CHANGE LIGHT BULBS
Use extreme caution when working from a ladder
or step stool.
When replacing light cover, make sure wires are
not pinched or near moving parts.
1. Disconnect power to door opener.
owerhead light cover.
ove light bulb(s).
ce light bulb(s).
– Do NOT use light bulbs with greater than
100 Watt rating.
owerhead light cover.
2. Reconnect power to door opener.
Test light operation.
RESET - OPEN/CLOSE TRAVEL LIMIT
Performing all ten (10) Limits/Force setting steps
(page 5) erases previous Limits/Force settings.
NOTE: The opener will not close the door
automatically unless the Safe-T-Beam® System is
installed and Limits are programmed.
DISENGAGING AND ENGAGING CARRIAGE
DISENGAGED
TO DISENGAGE, PULL
DOWN ON THE RELEASE
HANDLE AND LET GO.

REMOTE BATTERY REPLACEMENT

Replace remote battery with a
CR 2032 coin cell battery.
1. Open the remote case using a
washer or coin that fits into the
slot at the top of the remote.
2. Replace battery.
3. Align components and
snap case closed.
9
WARNING
OPENER
ENGAGED
TO ENGAGE, PULL
DOWN AND TOWARD
THE OPENER. THEN LET GO.
©2011 The Genie Company 9/2011