Install Light Bulbs And Lenses; Antenna Wire Installation - Genie M-4500 Owner's Manual

8-13. INSTALL LIGHT BULBS AND LENSES

DO NOT use a bulb with a rating higher than
60 Watts (W), or larger than a Standard size bulb.
A stronger or larger bulb may result in
fire or damage to the opener.
I Install a maximum 60 W bulb (not provided) into lamp
socket(s).
Fig. 33
Install Bulbs
Install Bulb
8-14. ANTENNA WIRE INSTALLATION (40MHZ)
Uncoil the gray antenna wire and position per diagram.
Fig. 34.
IMPORTANT NOTE:
I Do not lengthen or shorten the antenna wire.
I Make sure the antenna wire is directed away from system
power cord and any other power sources.
I Avoid fastening the antenna wire directly to any metal
surfaces. If stapling to joists or drywall, make sure staples
do not damage antenna wire.
16
Lamp Lens
Lamp Lens Tabs
Chassis Slots
Housing Slots
Snap lamp lens tabs
into slots in chassis
Lamp Lens
Lamp Lens Tabs
Chassis Slots
Housing Slots
Snap lamp lens tabs
into slots in chassis
I Install lamp lens(es). Two lenses for a M-4700 model, one
lens for a M-4500 model.
I Line up lamp lens tabs with slots in housing and snap
securely into place. Repeat same procedure with second
lamp lens on the opposite side, if you have an M-4700
power head.
I Line up lamp lens tabs with corresponding slots in chassis.
Snap lens onto chassis for M-4500 model.
I To remove lamp lens, pull lamp lens to unsnap from
housing and chassis.
M-4700
M-4500
Fig. 34
Powerhead
Hinge lamp lens downward,
line up tabs with slots in
housing, and snap into place.
Hinge lamp lens downward
line up tabs with slots in
housing, and snap into place.
Ceiling
Antenna wire