Table of Contents
Advertisement
WARNING:
A moving garage door may cause serious injury or death .
•
Keep people clear of opening while door is moving .
•
Do not allow children to play with the Remote Controls .
If the Safety Reverse does not work properly:
•
Close the door and disconnect the Opener using the
Emergency Release Cord .
•
Do not use the door Opener, Remote Controls, or
Wireless Keypad .
•
Refer to the door and door Opener Owner's Manuals
before attempting any repairs .
Remote Control Operation
A
Press Button on Remote Control . Garage door will move .
B
Press Button again . Garage door will stop:
•
The door automatically stops at the end of the open or
close cycle .
C
Press Button again . Garage door will reverse .
1 Button Compact Remote
w/Docking Station
Figure MA-4 Genie Remote Controls
Figure MA-5 Learn Code Button and Indicator Light
Figure 13 Learn Code Button and Indicator Light
To program a Homelink® or Car2U Device:
(This GDO is Homelink® and Car2U compatible)
• Follow the Homelink® or Car2U instructions in your car
owner's manual .
For Help, call 1-800-35-GENIE or visit www.geniecompany.com
3 Button Compact Remote
w/Docking Station
1 2 3 4
i
l
b
nStall
iGht
ulbS and
A Install two 60 Watt light bulbs (not included) into Light
Sockets (Figure MA-6):
• Rough service, 130 Volt bulbs are recommended .
B Hold the lens, with the bottom hinges pointing up, against
the power head metal front cover (Figure MA-7) .
• Insert (2) #8-32 x 3/8" Phillips Hex Head Screws
through the Bottom hinges and into holes provided
in metal front cover of Power Head (Figure MA-7) .
Tighten screws .
• Flip Lens up and fasten with (2) #8-32 x 3/8" Phillips Pan
Head Screws where indicated .
WARNING:
Use the Wall Console included with Opener . Any
other wall console can cause the Opener to operate
unexpectedly and the light to stop working .
Figure MA-6
Figure MA-7
l
enS
9
Hide quick links:
Advertisement
Table of Contents
