For use only with residential sectional or one piece overhead garage doors.
®
®
Homelink
and Car2U
compatible.
For Answers and Assistance:
1.800.354.3643
or visit www.geniecompany.com
WARNING: To reduce the risk of injury to persons or damage to property – Use this opener only with a one piece
or sectional door.
SAVE THIS MANUAL FOR FUTURE REFERENCE.
INSTALLER:
LEAVE THIS MANUAL WITH HOMEOWNER
Genie, Genie logo, Intellicode, Safe-T-Beam are registered trademarks of, and ChainMax is a registered trademark of GMI Holdings, Inc., dba The Genie Company.
There are no assembly or installation steps included in this manual. Contact your Genie® Professional Dealer for an installation poster, if required, or visit www.geniecompany.com to download a PDF file. The following mechanical assembly tasks must be completed before continuing.
.........POUR OBTENIR DE L’AIDE-1-800-35-GENIE INSTALACIÓN HABITUAL DE UNA PUERTA SECCIONAL ......... PARA OBTENER AYUDA, LLAME AL 1-800-35-GENIE *If required direct wiring of power supply to opener must be installed by a licensed electrician. Power cord must reach grounded outlet without use of extension cord.
.....POUR OBTENIR DE L’AIDE-1-800-35-GENIE INSTALACIÓN HABITUAL DE PUERTA DE UNA SOLA PIEZA ........PARA OBTENER AYUDA, LLAME AL 1-800-35-GENIE *If required direct wiring of power supply to opener must be installed by a licensed electrician. Power cord must reach grounded outlet without use of extension cord.
IntelliCode® 2 openers One or more openers Use IntelliCode® manufactured between 1997 5. Take the remote to the older Genie® garage door and 2010 (IntelliCode® 1) opener and follow that opener's instructions to program a new remote. NOTE: A maximum of 3 different openers can be programmed to a 3 button remote.
Bestimmungen der USA und Kanadas abweichen. MAINTENANCE & TROUBLESHOOTING FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.COM If you have any questions, please do not hesitate to contact customer service at: 1-800-35-GENIE IMPORTANT SAFETY INSTRUCTIONS WARNING: To reduce the risk of severe injury or death: 1.
WARNING WARNING k t , approved DO NOT tt DO NOT OPERATE Safe-T-Beam® (STB) SYSTEM CHECK automatically or manually i – CONTACT A TRAINED DOOR SYSTEM FROM STBs TECHNICIAN. FROM WALL CONSOLE ROUTINE MONTHLY MAINTENANCE – V Safe-T-Beam® System Check USED USED USED...
Wall consoles from other manufacturers may not work with Red indicator light is always ON openers of these serial number groups. Genie® Series I wall buttons and Series II wall consoles will not work with openers When Sure-Lock™ is ON the of this serial number group.
ADJUSTMENT GUIDE - SPEED SETTINGS FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.COM Speed settings are pre-programmed at the factory CHANGE SPEED SETTING for the maximum speed. Speed settings should not Use this guide to ADJUST powerhead SPEED settings. need adjustment with this unit.
ADJUSTMENT GUIDE - FORCE SETTINGS FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.COM CHANGE FORCE SETTING CAUTION Use this guide to ADJUST powerhead FORCE settings. Door closing force is FACTORY set and requires no NOTE: There are nine (9) force levels. adjustment for normal operation.
TROUBLESHOOTING GUIDE - OPERATION - FOR HELP - 1-800-35-GENIE OR WWW.GENIECOMPANY.COM PROBLEM WHAT TO DO rce, work , ow r ker. Opener does NOT run from wall console. re-L re-L , rok re . re . Opener runs, but door does NOT move.
TROUBLESHOOTING GUIDE - OPERATION (CONTINUED) ..............FOR HELP-1-800-35-GENIE PROBLEM WHAT TO DO Noisy operation. r, r Door opener runs slow. eet, TROUBLESHOOTING GUIDE - POWERHEAD LEDs FOR HELP-1-800-35-GENIE OR WWW.GENIECOMPANY.COM Powerhead LED Possible Problem Solution Round LED Long LED ter eren e...
............POUR OBTENIR DE L’AIDE-1-800-35-GENIE REFERENCIA - ESQUEMA ELÉCTRICO DEL CIRCUITO ............PARA OBTENER AYUDA, LLAME AL 1-800-35-GENIE Opener circuit wiring diagram. This wiring diagram is for reference only. Schéma de câblage de l’ouvreur. Ce schéma de câblage est indiqué à titre de référence uniquement.