Resetting The Main Unit; Switching The Speaker Impedance - Pioneer VSX-815-S/-K Operating Instructions Manual

Additional information

Resetting the main unit

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1 Switch the receiver into standby.
2 While holding down the TONE button,
press and hold the STANDBY/ON button for
about three seconds.
3 When you see RESET? appear in the
display, press ENTER .
OK? shows in the display.
4 Press SYSTEM SETUP to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.
Note
1 The button name is different for the VSX-515 (SPEAKER IMPEDENCE) and the VSX-815/915 (SPEAKERS) models.
Switching the speaker
impedance
We recommend using speakers of 8Ω with this
system, but it is possible to switch the
impedance setting if you plan to use speakers
with a 6Ω impedance rating.
• With the receiver in standby, press
STANDBY/ON while holding down the front
panel SPEAKER IMPEDENCE / SPEAKERS
button.
Each time you do this, you switch between the
impedance settings:
• SP 6 OHM – Use this setting if your
speakers are rated at 6Ω.
• SP 8 OHM – Use this setting if your
speakers are rated at 8Ω or more.
14
1
81
En