Resetting The Main Unit; Cleaning The Unit; Specifications - Pioneer VSX-D514 Operating Instructions Manual

Audio/video multi-channel receiver
Table of Contents

Advertisement

Available languages

Available languages

09
Additional information

Resetting the main unit

Use this procedure to reset all the receiver's
settings to the factory default. Use the front
panel controls to do this.
1
Switch the receiver on.
2
While holding down the TONE button,
press and hold the
for about three seconds.
3
When you see RESET? appear in the
display, press the TONE button.
OK? shows in the display.
4
Press TONE once more to confirm.
OK appears in the display to indicate that the
receiver has been reset to the factory default
settings.

Cleaning the unit

Use a polishing cloth or dry cloth to wipe
off dust and dirt.
When the surface is dirty, wipe with a soft
cloth dipped in some neutral cleanser diluted
five or six times with water, and wrung out well,
and then wipe again with a dry cloth. Do not
use furniture wax or cleansers.
Never use thinners, benzine, insecticide
sprays or other chemicals on or near this unit,
since these will corrode the surface.
48
En
STANDBY/ON button

Specifications

Amplifier Section
Continuous Power Output (Stereo RMS)
Front ............................................................. 80 W
Continuous Power Output (Surround RMS)
Front ........................................ 80 W per channel
Center ................... 80 W (1kHz, THD 1.0 %, 8 Ω)
Surround ................................. 80 W per channel
Above specifications are applicable when
the power supply is 230V.
Input (Sensitivity/Impedance)
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT ........................... 200 mV/47 kΩ
Frequency Response
CD, DVR/VCR, CD-R/TAPE/MD, DVD/LD,
TV/SAT ........................... 5 Hz to 100,000 Hz dB
Output (Level/Impedance)
DVR/VCR REC, CD-R/TAPE/MD REC
...................................................... 200 mV/2.2 kΩ
Tone Control
BASS .......................................... ± 6 dB (100 Hz)
TREBLE ...................................... ± 6 dB (10 kHz)
LOUDNESS .... +6.5 dB/+3 dB (100 Hz/10 kHz)
Signal-to-Noise Ratio [DIN (Continuous
rated power output/50 mW)]
CD, DVR/VCR, CD-R/TAPE/MD,
DVD/LD, TV/SAT .................................... 88/64 dB
(1 kHz, THD 1.0 %, 8 Ω)
(1kHz, THD 1.0 %, 8 Ω)
(1kHz, THD 1.0 %, 8 Ω)
+0
– 3
(at volume level –50 dB)

Hide quick links:

Advertisement

Chapters

Table of Contents
loading

Table of Contents