Other Connections; Second Zone Speaker B Setup; Switching The Speaker System - Pioneer VSX-815-S/-K Operating Instructions Manual

Other connections

Chapter 12:
Other connections
Caution
• Before making or changing the connections,
switch off the power and disconnect the
power cord from the power outlet.
Plugging in components should be the last
connection you make with your system.
• Be careful not to allow any contact
between speaker wires from different
terminals.
• You can use speakers with a nominal
impedance between 6–16Ω (please see
Switching the speaker impedance on
page 81 if you plan to use speakers with an
impedance of less than 8Ω).

Second Zone speaker B setup

VSX-915 model only
After selecting SB 2ND Z in Surround back
speaker setting on page 46, you can use the
speakers connected to the (surround back) B
speaker terminals on the rear panel to listen to
stereo playback in another room. See
Switching the speaker system below for the
listening options with this setup.
1 Connect a pair of speakers to the
surround back speaker terminals on the rear
panel.
Connect them the same way you connected
your speakers in Connecting the speakers on
page 22. Make sure to review Hints on speaker
placement on page 23 when placing the
speakers in another room.
Note
1 • The subwoofer output depends on the settings you made in Speaker setting on page 51. However, if SP B is selected above,
no sound is heard from the subwoofer (the LFE channel is not downmixed).
• Depending on the Surround back speaker setting on page 46 output from the surround back pre-out terminals may change.
• All speaker systems (except SB 2ND Z connections) are switched off when headphones are connected.
2 Select SB 2ND Z from the ' SB. SYSTEM'
menu.
See Surround back speaker setting on page 46
to do this.

Switching the speaker system

If you selected SB 2ND Z in Surround back
speaker setting on page 46, three speaker
system settings are possible using the
SPEAKERS button. If you selected SB NORM.
or SB BIAMP, the speaker system is fixed as
SP A or SP AB (respectively). The options
below are for the SB 2ND Z setting only.
• Use the SPEAKERS button on the front
panel to select a speaker system setting.
INPUT
FL DIMMER ATT SPEAKERS
TUNING TUNER
BAND /STATION EDIT
Press repeatedly to choose a speaker system
option:
• SP A – Sound is output from the speakers
connected to the A speaker terminals
(multichannel playback is possible).
• SP B – Sound is output from the two
speakers connected to speaker system B
(only stereo playback is possible).
1
EXTENDED ACOUSTIC
MODE EQ
QUICK SYSTEM
TONE SETUP SETUP RETURN
MULTI JOG
12
71
En