Controlling The Rest Of Your System (Vsx-515); Setting The Remote To Control Other; Components; Selecting Preset Codes Directly - Pioneer VSX-815-S/-K Operating Instructions Manual

10 Controlling the rest of your system
Chapter 10:
Controlling the rest of your
system
VSX-515 model only
Setting the remote to control
other components
Most components can be assigned to one of
the MULTI CONTROL buttons using the
component's manufacturer preset code stored
in the remote.
However, please note that there are cases
where only certain functions may be
controllable after assigning the proper preset
code, or the codes for the manufacturer in the
remote control will not work for the model that
you are using.
Note
• After one minute of inactivity, the remote
automatically exits the operation.

Selecting preset codes directly

RECEIVER
INPUT SELECT
MULTI CONTROL
DVD/LD TV / SAT DVR/VCR
C D CD-R/TAPE TUNER
ADVANCED STEREO/
STANDARD SURROUND DIRECT
1 While pressing the RECEIVER button,
press and hold the 1 button.
The LED blinks.
Note
1 • TV codes (for example, codes for TV, CATV, Satellite TV or DTV) can only be assigned to the TV/SAT or TV CONT button.
• You can't assign the TUNER or RECEIVER buttons.
58
En
DISPLAY CLASS MPX D.ACCESS
SOURCE
DISC
ENTER
TV CONT
RECEIVER
MIDNIGHT/
TV CONTROL
LOUDNESS
2 Press the MULTI CONTROL button for the
component you want to control.
The LED lights.
3 Use the number buttons to enter the
preset code.
You can find the preset codes on page 63.
The LED blinks again after you enter the code.
If the correct code has been input the power of
the component being input will turn on or off.
The power of the component being input will
only turn on or off if that component is able to
be turned on directly by remote control.
• You can only input a code for the compo-
nent type written on each MULTI
CONTROL button.
• Even if you don't input a preset code for the
TV (TV/SAT MULTI CONTROL button) you
will be able to control your TV using the
dedicated TV CONTROL on the remote if
you have assigned it to the TV CONT
button.
4 Repeat steps 2 through 3 to try a different
code, or to enter a code for another
component you want to control.
10
5 When you're done, press RECEIVER.
1