Acoustic Calibration Eq - Pioneer VSX-815-S/-K Operating Instructions Manual

The System Setup menu
• If you want to go back and adjust a
channel, simply use
right) to select it.
4 When you're finished, press RETURN.
You will return to the Manual MCACC setup
menu.

Acoustic Calibration EQ

Acoustic Calibration Equalization is a kind of
room equalizer for your speakers (excluding
the subwoofer). It works by measuring the
acoustic characteristics of your room and
neutralizing the ambient characteristics that
can color the original source material. This
provides a 'flat' equalization setting. If you're
not satisfied with the automatic adjustment,
you can also adjust these settings manually to
get a frequency balance that suits your tastes.
Setting the Acoustic Calibration EQ
automatically
If you have already completed Automatically
setting up for surround sound (MCACC) on
page 11, A. CH ADJ and F.ALG ADJ (below)
should already be set. Therefore, if you want to
adjust your settings manually, you can skip to
Setting the Acoustic Calibration EQ manually
below.
1 Select ' EQ A. SET ' from the Manual
MCACC setup menu.
• Make sure the microphone is connected.
• If you're using a subwoofer, it is
automatically detected every time you
switch on the system. Make sure it is on
and the volume is at the middle position.
• See Other problems when using the Auto
MCACC Setup on page 13 for notes
regarding high background noise levels
and other possible interference.
2 Wait for the Auto MCACC Setup to finish.
As the receiver outputs test tones, the
frequency balance is adjusted automatically
for the following settings:
• A. CH – All Channel Adjust is a 'flat' setting
(cursor left/
• F.ALG – Front Align Adjust balances the
You will return to the Acoustic Cal EQ setup
menu after the Acoustic Calibration
Equalization is set.
Copying your Acoustic Calibration EQ
settings
If you want to manually adjust the Acoustic
Calibration EQ (see Setting the Acoustic
Calibration EQ manually below), we
recommend copying the A. CH or the F.ALG
settings from the EQ A. SET setup above (or
from Automatically setting up for surround
sound (MCACC) on page 11) to one of the
custom (C1 or C2) settings. Instead of just a flat
EQ curve, this will give you a reference point
from which to start.
1
setup menu.
2
or C2 then use the
buttons to select the setting you want to
copy.
• You can also copy from one custom setting
3
'COPY? YES' to copy and confirm.
You can also use
select COPY? NO to cancel.
where all the speakers are set individually
so no special weighting is given to any one
channel.
overall sound so that all speakers are set in
accordance with the front speaker settings
(no equalization is applied to the front left
and right channels).
Select 'EQ COPY' from the Manual MCACC
Use (cursor left/right) to select C1
(cursor up/down)
to another. For more on the A. CH and
F.ALG settings, see Setting the Acoustic
Calibration EQ automatically above.
Use (cursor left/right) to select
(cursor up/down) to
07
49
En