GE JGS968 Owner's Manual page 41

GEApp/iances.com
Possible Causes What To Do
Controisignals after You forgot to enter a = Touch the BAKE pad and desired temperature or
entering cooking time bake temperature or the SELF CLEAN STD/LOW pad and desired clean time.
or start time cleaning time.
Oisplaygoes blank
A fuse in your home may • Replace
the fllse or reset the circuit
breakel:
be blown or the circuit
breaker tripped.
The clock is in the • See the Special features of your oven control section.
black-out mode.
Display flashes Power failure. • Reset the clock.
Unable to get the Oven control pads were • The BROIL HI/LO and BAKE pads must be touched at
display to show "SF"
not touched properly, the same time and held fbr 3 seconds.
"Probe"appears in This is reminding you to • Enter a probe temperatme.
the display enter a probe temperature
after plugging in the probe.
Power outage, Power outage or surge. • Reset the clock. If the oven was in use, yo/_ must reset
clock flashes
it by touching
the CLEAR/OFF pad, setting
the clock
and resetting any cooldng fimcfion.
Steam from the vent When using the convection • This is normal.
feature, it is normal to see
steam coming out of the oven
vent. As the number of racks
or amount of food being
cooked increases, the amount
of visible steam will increase.
"Burning" or "oily" This is normal in a new oven • To speed the process, set a self'clean cycle for a
odor emitting from
and will disappear in time. minimmn of 3 hems.
See the Using the self-cleaning
the vent
oven section.
Strong odor
An odor from the insulation • This is temporary.
around the inside of the oven
is normal for the first few times
the oven is used.
Fannoise
A cooling fan or a convection • This is normal. The cooling tim will mrn off and
fan (depending on the on to cool internal parts. [t may run after the oven is
function you are using) may turned OFF The convection fan will cycle on and off
automatically turn on and off. until the fimcfion is over or the door is opened.
4/