SATO CL408 Programming Reference Manual page 158

SENSOR TYPE
FUNCTION
To select a label sensing method for a print job.
FORMAT <ESC>IGa
Place in separate data stream sent to the printer.
EXAMPLE <ESC>A
<ESC>IG1
<ESC>Z
OUTPUT This command does not result in printer output.
NOTES
When the power is cycled, the value set by this command is lost and replaced by the default value
stored in the EEPROM.
To change the value stored in the EEPROM, use the Printer Setting (<ESC>PC) command.
The sensor type may also be set by the use of DSW2-2. The setting priority is determined by the
priority setting in the LCD,
E/Pro Programming Reference
Unit 4: Standard Command Codes
a = 0: Reflective (Eye-Mark) sensor
1: Gap (transmissive) sensor
2: Sensor not used.
4-106
PN: 9001096E