Insert the four wires through the
a
strain relief plate (NOTE: Put the
larger, male connectors through
first).
=
c
Secure the strain relief plate
to the firebox floor with the
screws removed earlier.
If using the optional wall-mounted rheostat, follow the directions on the following page "Wall Mounted
Rheostat".
Secure the wires using the included strain relief
b
(wrap the strain relief over the wires, compress
with pliers, then insert into the hole).
Route the wires behind the pilot
d
assembly. There are two small tabs on
the pilot bracket that can be bent down to
secure the wiring. All wiring must be
secured away from the burner.
Attach the quick-connects from the
b
rheostat to the quick-connects from
the accent light assemblies
(orientation does not matter). Plug
the rheostat into the receptacle.
Attach the rheostat assembly to the
a
fireplace with the included screws.