Controller Connection - Runco XtremeProjection X-200i Installation & Operation Manual

Connect a PC or home theater control/automation system (if present) to the RS-232 port
on the X-200i; see Figure 3-14. Use a standard, 9-pin serial cable, wired straight-through.
For more information about using this connection, refer to External Control on page 81.
POWER POWER
POWER POWER
LED STATUS LED STA T T TUS
STATUS TUS A A STA T T
WIRED REMOTE WIRED REMOTE
REMOTE REMOTE WIRED WIRED
I I II II
to Automation/
Control System
or PC
Figure 3-14. RS-232 Control System Connection
Runco X-200i Series Installation/Operation Manual
ISSUE ISSUE
ISSUE ISSUE
A A
LED LED
RS-232 USB USB
RS-232 USB USB
SOURCE SOURCE
SOURCE SOURCE
POWER POWER
POWER POWER
COMPONENT 1 COMPONENT 1
1 1 COMPONENT COMPONENT
5 4 3 2 1
6
9 8 7
2 Receive Data
(to ctrl. system)
3 Transmit Data
(from ctrl. system)
5 Ground
(none of the other pins are used)
33
Installation
RS-232 Controller
Connection