Installing The Optional Cinewide/Autoscope Lens Motor (Cl-810 Ultra Only); Cl-810 Ultra/Cinewide With Autoscope Motor Assembly - Exploded View - Runco Reflection CL-810 CineWide Owner's Operating Manual

Installation
3.4
Installing the Optional
CineWide/AutoScope
Lens Motor (CL-810
Ultra only)
If you are installing an CL-810 Ultra with the optional CineWide with AutoScope system,
proceed as follows to install the AutoScope lens motor. Otherwise, skip this step and
proceed with Mounting the CL-810 (page 25).
1. Do not install the CineWide lens yet, only the AutoScope lens
Note
2. Some components may differ slightly from what is shown in
Figure 3-6 shows the CL-810 Ultra/CineWide with AutoScope motor assembly.
Screw, Phillips Flat-Head,
CineWide with
3
AutoScope
Ceiling Mount
Adapter/
Projector Stand, Right
5
Screw, Phillips
Pan-Head,
1/4-20 x 1/2" (8x)
AutoScope Lens
7
Motor Mounting
Plate
Figure 3-6. CL-810 Ultra/CineWide with AutoScope Motor Assembly – Exploded
View
motor. You will install the CineWide lens after you install the
projector and adjust the primary lens.
these instructions.
1
M6 x 16mm (2x)
22 Runco CL-810 Series Owner's Operating Manual
2 Screw, Phillips
Pan-Head,
M6 x 1.0 x 12mm
(2x)
4 CineWide with
AutoScope Ceiling
Mount
Adapter/Projector
Stand, Left
6 AutoScope
Lens Motor