Ohp Transparencies - Ricoh MLP36n Manual

5. Paper and Other Media
Both-sided printing
Additional cautions

OHP transparencies

Printer setup
Printer driver setup
Enabled paper feeding tray
5
Number of sheets that can be set
Both-sided printing
Additional cautions
Envelopes
Printer setup
Printer driver setup
80
Not possible
Print speed is slightly slower than when using plain paper.
Make the following settings using the control panel:
• Press the [Menu] key, select [Paper Input], and then select
[Transparency] for the bypass tray's paper type.
Click [OHP Transparency] in the "Paper type:" list.
This paper type can be printed only from the bypass tray.
Bypass Tray: 20
• Make sure paper is not stacked higher than the paper guides
inside the bypass tray.
Not possible
• Print speed for OHP transparencies is slower than for plain
paper.
• Depending on the setting made for mode switching, the
printer goes into standby mode 30 or 40 seconds after
receiving a job.
• We recommend you use a 4000 ANSI lumen or brighter
overhead projector to project OHP transparencies.
• When printing on OHP transparencies that have a print side,
load them with the print side facing up on the bypass tray.
Make the following settings using the control panel:
• Press the [Menu] key, select [Paper Input], and then select
[Thick Paper] for the selected tray's paper type.
• Paper type settings made using the printer driver have
priority over paper type settings made using the control
panel settings.
Click [Thick] in the "Paper Type:" list.