Ricoh MLP36n Manual page 474

6. Monitoring and Configuring the Printer
Client password rejected
Client tls certificate rejected
Connected DHCP Server(<DHCP serveraddress>). The IP address was successfully received from the
Could not attach to FileServer<error number>
Could not attach to PServer<print server>
6
Current Interface Speed: xxxMbps
Current IP address <currentIP address>
Current IPX address<IPX address>
DHCP lease time expired.
DHCP server not found.
dhcpcd start.
Duplicate IP=<IP address>(from<MAC address>). The same IP address (IPv4, or IPv6 address) was
Established SPX Connection with PServer,
(RPSocket=<socketnumber>, connID=<connection
ID>)
250
Message Problem and solutions
The client's password was rejected. Check the client
password.
The client's TLS certificate was rejected. Check the
certificate.
DHCP server.
(In the remote printer mode) Connection to the file
server has not been established. The file server has
refused the connection. Check the file server
configuration.
(In the remote printermode) Connection to the print
server has not been established. The print server
has refused the connection. Check the print server
configuration.
Speed of the network (10Mbps, 100 Mbps, or
1Gbps).
Current IPv4 address.
Current IPX address
DHCP lease time has expired. The printer tries to
discover the DHCP server again. The IP address
until now becomes invalid.
The DHCP server was not found. Make sure that the
DHCP is on the network.
The DHCPCD service (dhcp client service) has
started.
used. Each IP address (IPv4, or IPv6 address) must
be unique. Check the address of the device
indicated in [MAC address].
(In the remote printer mode) Connection to the print
server has been established.