Modbus Data Listing - Hitachi SJ2002 Series Instruction Manual

ModBus Data Listing

ModBus Coil List
The following tables list the primary coils for the inverter interface to the network. The
table legend is given below.
• Coil Number - The network register address offset for the coil, in hex and decimal.
Actual network address is 30001 + offset. The coil data is a single bit (binary) value.
• Name - The functional name of the coil
• R/W - The read-only (R) or read-write (R/W) access permitted to the inverter data
• Description - The meaning of each of the states of the coils
Coil Number
hex dec.
0000h 00000 (Reserved)
0001h 00001 Run command
0002h 00002 FW/REV command
0003h 00003 External trip (EXT)
0004h 00004 Trip reset (RS)
0005h 00005 (Reserved)
0006h 00006 (Reserved)
0007h 00007 Intelligent input terminal 1
0008h 00008 Intelligent input terminal 2
0009h 00009 Intelligent input terminal 3
000Ah 00010 Intelligent input terminal 4
000Bh 00011 Intelligent input terminal 5
000Ch 00012 Intelligent input terminal 6
000Dh 00013 (Not used)
000Eh 00014 Run/Stop status
000Fh 00015 FW/REV status
0010h 00016 Inverter ready
0011h 00017 (Reserved)
List of Coil Numbers
Name R/W
R
R/W 0 .... Stop
R/W 0 .... REV
R/W 0 .... No trip event
R/W 0 .... No reset condition
R
R
R/W 0 .... OFF *1
R/W
R/W
R/W
R/W
R/W
—
R
R
R
R
SJ200 Inverter
2
Description
—
1 .... Run (enabled when A003=03)
1 .... FW (enabled when A003=03)
1 .... Trip occurred
1 .... Reset
—
—
1 .... ON
—
0 .... Stop (corresponds to D003
monitor)
1 .... Run
0 .... FW
1 .... RV
0 .... Not ready
1 .... Ready
—
B–19