Headstock Movement; Raising/Lowering Headstock; Rotating Headstock; Tilting Headstock - Grizzly G0751 Owner's Manual

Headstock
Movement
the headstock travels up and down the column,
rotates around the column 180° in each direction,
and tilts 90° left and right relative to the table.

Raising/Lowering Headstock

Tool Needed
Wrench 24mm ................................................... 1
Loosen the locking
Figure 12, then use the headstock z-axis crank
(see Figure 13) to raise/lower the headstock.
hex nuts
Figure 12. headstock locking hex nuts.
headstock
z-axis
Crank
Figure 13. headstock z-axis crank location.
Lock the headstock in place by retightening the
locking hex nuts before beginning operation to
avoid unexpected headstock movement.
-22-
Qty
hex nuts shown
Locking

Rotating Headstock

Tool Needed
Wrench 24mm ................................................... 1
Loosen the locking hex nuts shown in Figure 12,
then slowly rotate the headstock around the col-
umn. Lock the headstock in place by retightening
the locking hex nuts before beginning operation to
avoid unexpected headstock movement.

Tilting Headstock

Tool Needed
Wrench 22mm ................................................... 1
in
Loosen the three tilt locking hex nuts—one on
each side of the headstock (see Figure 14) and
one underneath the headstock (see Figure 15).
Figure 14. headstock tilt locking hex nuts.
Locking
hex nut
(Underneath)
Figure 15. headstock tilt hex nut underneath.
slowly tilt the headstock to the desired angle, then
retighten the tilt locking hex nuts before beginning
operation to avoid unexpected headstock move-
ment.
Locking
hex nut
(1 on each side)
Model G0751 (Mfg. Since 1/13)
Qty
Qty