Motion Configuration - Q-See QSD2316L User Manual

Alarm out hold time(S): Set relay alarm out time after alarm is triggered.
Buzzer hold time(S): set on board buzzer time after alarm is triggered.
4.2.6

Motion Configuration

Click MOTION to enter motion configuration shown as Fig 4.11 Motion Configuration.
Here users can set motion sensitivity, detection area and alarm out. The following are the definitions of each option:
Enable: Enable motion detection.
Trigger: Setup similar with that of sensor alarm, but linked speed domes need to use different channels, i.e. if users
enable motion detection on camera 1, the linked speed domes must be cameras 2-16.
Area: Set sensitivity and motion detection area. DVR supports multiple detection areas as shown in Fig 4.12
Detection Area Configuration. Click the blocks or drag mouse to enable or disable. Red means unavailable,
transparent means available. Click Save to save and exit.
QSD2316L DVR User's Manual
Fig 4.11 Motion Configuration
55