Motion Configuration - Q-See QT5116 User Manual

MAIN MENU GUIDE
QT518 & QT5116 User Manual
Here users can set sensor type, alarm trigger and alarm time. The following are the definitions of each option.
Device Type: NC and NO (Normal Close and Normal Open). Set the value according to the alarm signal level of the
sensors.
Enable: Enable sensor alarm.
Trigger: Set alarm output, recording channel and speed dome linking. Click the Set button, a window will appear
shown as Fig 4.10 Alarm Out Configuration.
Fig 4.10: Alarm Out Configuration
Alarm Out: Set relay alarm out channel. You can select any alarm channels.
To Record: Set recording channels. You can select any record channels. It will record on the cameras you choose
here when alarm is triggered.
Buzzer: Enable on board buzzer for alarm.
To P.T.Z CH: Set linked preset and cruise for alarm. You can select any channel and multi channels as linked
channels.
Alarm in Hold Time (S): The interval time between two consecutive sensor alarm events. If a second alarm is
detected within Hold time, it is recognized as a continuous alarm. If a second alarm is detected after hold time, the
second alarm and the previous one are recognized as two different alarm events.
Alarm out Hold Time (S): Set relay alarm out time after alarm is triggered.
Buzzer Hold Time (S): set on board buzzer time after alarm is triggered.

4.2.6 Motion Configuration

From the Pop-Up Menu illustrated in Fig 4.3 System Setup, select Motion and a user interface for all the Motion
functions available will appear as illustrated in Fig 4.11 Motion Configuration.
Fig 4.11: Motion Configuration
35 | P a g e