3.6 PTZ Control
Please connect speed domes to the DVR via RS485 first, refer to 2.3.1 Rear Panel Interface. Make sure the speed
dome has a protocol this DVR supports and set the parameters according to its manual.
Press right mouse button to show the control bar. Enter Menu---->System--->P.T.Z, see Fig 3.26.
STEP1
Set protocol, baud rate, and address according to the parameters of the speed dome.
STEP2
Click Set button at right of Preset. Here users can set presets, shown as Fig 3.27 Set Presets. Adjust the
STEP3
speed dome. Select a preset and click to save. Users can set 16 presets total.
40
Digital Video Recorder User Manual
Fig 3.26 PTZ Setup