Q-See QSD2316L User Manual page 32

Enter Trigger configuration, see Fig 3.12 Alarm Out Setup
STEP3
Select alarm out and recording channels. It can trigger any alarm out and cameras to record once motion is
STEP4
detected.
Enable or disable Buzzer on board. Select speed dome (PTZ) and enable preset or auto cruise. Press OK to
STEP5
save
Set Hold time. It is the interval time between two consecutive motion events. If a second motion event is
STEP6
detected during the Hold time, it is recognized as a continuation of the first motion event. If a second motion is detected
after Hold time, this motion and the previous are recognized as two different motion events.
Click OK to save settings
STEP7
Enter SCHEDULE configuration. Select Motion and relative cameras to set, refer to 3.3.3 Schedule
STEP8
recording.
Note: About preset and auto cruise, users can only select one or the other..
The actual post alarm record time equals Hold time in RECORD and Hold time in MOTION
26
Digital Video Recorder User Manual
Fig 3.12 Alarm Out Setup