Viewing The Odometer, Hours Of Use, Software Version And Error Log - Precor EFX5.33 Owner's Manual

Viewing the Odometer, Hours of Use, Software Version and Error Log

From the Precor banner and press the following key sequence:
Reset, Enter, Quick Start
The numbers 6, 5 appear on the display as you press the associated key.
The field name Odometer appears briefly and then the odometer value (the cumula-
tive strides users have travelled) appears. When either Select key is pressed the
word "STRIDES" appears on the display. When the key is released, the odometer
value reappears.
Press Enter and the number of hours (Hour Meter) that the unit has been in use
appears. The EFX notes the passing of minutes, but the numeric value that appears
is truncated to the nearest full hour.
Press Enter again and the unit's three digit SW Version (upper board software
version number) appears on the display.
Press either Select key to view the lower board's version number. The Select key
toggles between the two versions.
Press Enter once again and the Error Log appears. Press any or key to view
the error codes.
To view the odometer reading at the time the error was detected and the hours of use
at the time the error occurred, press either Select key while the error code is being
displayed. The Select keys act as toggles between the associated information.
Note: To clear (delete) the error log, press Quick Start for at least four seconds while
viewing the list. Prompts appear on the display and let you know when the error
messages have been deleted ("cleared" from memory).
Important: You cannot retrieve the error log once you have deleted it.
To return to the Precor banner, press Enter or Reset.
page 31