Attaching Frame Stabilizers To Upright Brackets; Attaching Lower Frame To Base Assembly - Precor EFX5.33 Owner's Manual

Attach the frame
Diagram 9
stablizers to the
upright support
brackets.
Bolts (G) and
washers (H)
Frame stabilizer
11. Attach the left and right frame stabilizers. Take the following steps to install
a.
b.
c.
d.
e.
Diagram 10 Attach the lower
frame stabilizers
to the base
assembly.
Bolts
f.
h.
the frame stabilizers onto the base assembly.
Note: Proceed with one side at a time. When you have installed the first stabi-
lizer, perform the same steps on the opposite stabilizer.
Remove eight bolts (G) and eight washers (H) from the Hardware kit. Place a
washer on each bolt and set the fasteners within easy reach of the unit.
Grasp one of the frame stabilizers and align it with the upright support bracket.
Insert four bolts (G) with washers (H) through the frame stabilizer and upright
support bracket. See Diagram 9.
Thread all four bolts and washers until the frame stabilizer is secure. Do not fully
tighten the bolts until after the lower section is attached to the base assembly.
Perform steps a through d on the opposite side.
Carefully align the mounting holes on the right and left frame stabilizer with the base
frame holes. Insert four bolts (G) and washers (H) on both sides. Thread the bolts
through the unit. See Diagram 10. You may need to adjust and gently move the
stabilizers up and down to get the mounting holes on both sides of the base frame
properly aligned.
Tighten the bolts so that the unit is stable, but leave room for final adjustments.
Do not securely tighten the bolts until the unit has been fully assembled.
Upright
support
bracket
Upper section
Lower section
page 15