Level Unit; Insert Power Plug; Turning The Unit On And Off - Precor EFX5.33 Owner's Manual

Elliptical fitness crosstrainer
Hide thumbs Also See for EFX5.33:
Table of Contents

Advertisement

Diagram 15
Diagram 16
page 18
Level the unit.
Front end
Height adjustor
Rotate rear
adjustment feet.
17. Level the unit. Diagram 15. To help keep the unit stable, the EFX
able rear feet and, at the front of the base assembly, a height adjustor. Check to
make sure that the unit does not wobble from side to side or front to back.
Important: If the unit is placed on a slightly, uneven surface, adjusting the rear
feet can help, but will not compensate for extremely uneven surfaces.
a.
To remove any side to side movement or wobble, rotate the rear feet.
b.
To counteract any rocking (front to back) motion, ask your assistant to grasp
the upright support so that he or she can raise the front of the unit off the floor.
Use a crescent or combination wrench to loosen the nut. See Diagram 15.
Turn the height adjustor clockwise to raise the height of the front end.
Turn the height adjustor counterclockwise to lower the height.
Once you have the proper height adjustment, use the wrench to turn the nut
counterclockwise and tighten it securely.
Insert the power
plug.
Power plug
ON/OFF (I/O) switch
18. Connect the power cord. Diagram 16. Insert the power plug's connector into the
receptacle at the rear of the base assembly.
CAUTION: Use the supplied power cord. Do not remove or otherwise
bypass the 3-prong plug with an adapter in order to use a non-grounded
outlet. Do not plug the EFX into a power transformer in an attempt to adjust
the voltage requirements. Failure to follow these instruction's might
damage the unit and void Precor's limited warranty.
19. Plug the EFX into a grounded outlet. Be sure to use the appropriate voltage
requirements. Refer to Grounding Instructions on page 5 .

Turning the Unit ON and OFF

Use the ON/OFF (I/O) power switch to turn the unit ON and OFF. This switch is
located at the rear of the unit, near the power cord receptacle. Refer to Diagram 16.
Use the I/O power switch to turn OFF the EFX and unplug the unit from the power
outlet when it is not in use for extended periods of time.
®
5.33 has adjust-

Hide quick links:

Advertisement

Table of Contents
loading

Table of Contents