Viewing Other Settings; Viewing The Error Log - Precor EFX 5.25 Assembly Manual

Viewing Other Settings

The EFX stores the total number of strides and the total
number of hours the unit has been in use. You can view this
information by performing the following steps:
1. At the Precor banner, press and hold ENTER while
pressing the following keys in sequence without pause:
RESET, CROSSRAMP ▲, RESISTANCE ▼
The software part numbers scroll across the center
display while the odometer and hour meter scroll across
the lower display.
2. Write the software part numbers below. You will need
these numbers if you call Customer Support with
questions. This information will help rule out any
software-related problems:
UPPER: ___________________
LOWER: ___________________
3. When you are ready, press RESET to return to the
Precor banner.
Owner's Manual: Advanced Programming and Troubleshooting

Viewing the Error Log

The error log displays information about errors that may
have occurred while using the EFX. Up to ten errors are
recorded along with the odometer and hour meter values
at the time the error occurred.
1. At the Precor banner, press and hold the RESET key
for at least four seconds to view the error log. The most
recent error recorded appears on the lower display.
Refer to Figure 8.
Note: If there are no errors in the log, NO ERRORS
appears on the display.
Most recent
1‐Error 40 AT 1234567 STRIDES 1714 HOURS
Error code
Figure 8: Error log
The hour meter at the
time the error was
Odometer reading at
the time the error
36