Advanced Techniques For The Efx5.33; Programming Tips; Selecting A U.s. Standard Or Metric Display - Precor EFX5.33 Owner's Manual

5
page 30
Advanced Techniques for the EFX
Several aspects of the EFX can be programmed. This section provides instructions
on how to:
• select U.S. standard or Metric display
• view the odometer, hours of use, software version, and error log

Programming Tips

Certain aspects of the EFX are hidden and can only be accessed using special key
presses. To avoid unauthorized use, certain rules apply. Tips to consider while
programming or viewing diagnostic information are shown below:
• Always start at the Precor banner.
• The advanced programming and diagnostic mode is accessed by pressing the
Reset key while the Precor banner is displayed. A second key press must occur
within 1/3 second after pressing Reset or the display returns to the Precor
banner. The third and subsequent key presses must occur within four seconds of
the previous key or the system returns to the Precor banner and you will need to
begin again.
• The Select and keys let you toggle and view information pertinent to the
program.
• Exit the programming or diagnostic mode by pressing Reset. Note that the display
remains blank for one second and any additional key presses are ignored.

Selecting a U.S. Standard or Metric Display

The EFX can display units of measure in either U.S. Standard or Metric. When the
EFX is shipped from the factory it is set to display the U.S. Standard. You can easily
change this setting by taking the following steps:
1. Check that the EFX is ON. If necessary, turn ON the EFX using the power switch
located at the rear.
2. At the Precor banner, press the following keys in sequence:
Reset, Quick Start, Enter, Select [2], Resistance
the display)
The numbers 5, 6, 7, 1 appear on the display as you press the associated key.
Important: If the second key press (Quick Start) is not pressed within
1/3 second after pressing Reset, the display returns to the Precor banner. You
will need to begin again.
3. The prompt, "Select Units" appears on the display. Then, the current unit of
measure appears. Any
4. Once your selection is displayed, two options exist. You can,
a. press Enter to accept the unit of measure being displayed and continue with
programming the EFX. The changes are saved in memory. The EFX will
retain your selection even when it is turned OFF and unplugged.
b. press Reset which keeps the "current unit of measure" unchanged, ends the
programming mode, and returns to the Precor banner.
Note: The "current unit of measure" is not necessarily the one being
displayed. It refers to the unit of measure that was in existence prior to
entering the "Select Units" program.
or key lets you alternate between the prompts.
®
5.33
(on the far left as you face