Viewing The Odometer, Hours Of Use, Software Version And Error Log - Precor Move Beyond EFX556 NAVY Owner's Manual

C O M M E R C
VIEWING THE ODOMETER, HOURS OF USE, SOFTWARE
VERSION AND ERROR LOG
The keypad keys that you press to view the odometer, the number of hours the
EFX has been in use, the software version and any error codes, are as follows:
Reset, ▲, ▼
Important: Remember to begin at the Precor banner. After pressing Reset, the
next key in the sequence must be pressed within 1/2 second. The numeric
keypad can be used instead. For example: Reset 6, 5.
The field name Odometer appears briefly and then the odometer value (the
cumulative strides that users have travelled) appears.
Press Enter and the number of hours (Hour Meter) that the unit has been in use
appears. The EFX notes the passing of each 10th of an hour, but the numeric
value that appears is truncated to the nearest full hour.
Press Enter again and the unit's three digit Software Version (upper and lower)
appears on the display.
Diagram 26
Most recent error
1: ER33
Error code
Press Enter once again and the Error Log appears. Press the ▼ or ▲ key to
scroll through the error messages. Refer to Diagram 26. If you need technical
support, refer to Obtaining Service on page 7.
To return to the Precor banner, press Enter or Reset.
Note: To clear (delete) the error log, press QuickStart for at least four seconds
while viewing the list. Prompts appear on the display and let you know when the
error messages have been deleted ("cleared") from memory.
Important: You cannot retrieve the error log once you have deleted it.
I A L P R O D
The number of hours that the EFX has been in
use when the error occurred
AT 12,345,678 STRIDES 1,714 HOURS
Odometer reading at the time the error occurred
U C T S D I V I S I O N
page 45