Load Best Defaults; Set Supervisor/User Password - Foxconn NF4UK8AA series User Manual

Chapter 3 BIOS Description

Load Best Defaults

Select this item and press <Enter>, it will open a dialogue box that lets you
install the best defaults for all appropriate items in the Setup Utility. Select <Y>
and press <Enter> to load the best defaults. Select <N> and press <Enter> to
not install. The defaults set by BIOS have set the best performance parameters
of system to improve the performances of system components. But if the best
performance parameters to be set cannot be supported by your hardware
devices, it can cause fatal errors or instability. If you only want to load the best
defaults for a specific option, you can select this option and press the <F7> key.

Set Supervisor/User Password

The preferential grade of supervisor password is higher than user password.
You can use supervisor password to start into system or enter into CMOS set-
ting program to amend setting. You can also use user password to start into
system, or enter into CMOS setting menu to check, but if you have set supervisor
password, you cannot amend the setting.
Highlight the item Set Supervisor / User Password on the main menu and press
<Enter>. The following password dialog box appears:
Enter Password:
Enter your password, not exceeding 8 characters, then press <Enter>, you will
be prompted to confirm the password, type in the password again and press
<Enter>.
If you are deleting a password that is already installed, just press <Enter> when
the password dialog box appears, and the screen will show a message that
indicates this password has been disabled. In this case, you can freely enter
into system and CMOS setting program.
PASS WORD DISABLED!!!
Press any key to continue...
Under the menu "Advanced BIOS Features Setup", if you select "System" in
Security Option, the screen will prompt you to enter password once the system
is started or you want to enter CMOS setting program. If the password is wrong,
it will refuse you to continue.
Under the menu "Advanced BIOS Features Setup", if you select "Setup" in Secu-
rity Option, the screen will prompt you to enter password only when you enter
CMOS setting program.
47