Foxconn NF4UK8AA series User Manual page 47

Chapter 3 BIOS Description
UART Mode Select (Default: IrDA)
Use this item to select the UART mode. Setting values include Normal,
IrDA, ASKIR. The setting value is determined by the infrared module installed
on the board.
UR2 Duplex Mode (Default: Half)
This item is available when UART Mode Select is set to either ASKIR or IrDA.
This item enables you to determine the infrared function of the onboard infrared
chip.
Onboard Parallel Port (Default: 378/IRQ7)
This item allows you to determine onboard parallel port controller I/O address
and interrupt request (IRQ).
Parallel Port Mode (Default: SPP)
This item is used to assign data transport protocols of parallel port. The
available options: SPP, EPP, ECP, ECP+EPP and Normal. Normal mode
supports data output only; ECP and EPP mode support data input and output
in bidirectional mode, but they just fit known ECP and EPP devices.
ECP Mode Use DMA (Default: 3)
Select a DMA Channel for the parallel port when using the ECP mode. This
field is configured only if Parallel Port Mode is set to ECP.
PWRON After PWR-Fail (Default: Off)
This item is used to set what action the PC will take with the power supply
when it resumes after a sudden power failure. The available options are: Off
(remain in turn off status), On (auto power on) and Former-Sts (resume with
the previous status).
39