Foxconn NF4UK8AA series User Manual page 51

Chapter 3 BIOS Description
HDD Power Down (Default: Disabled)
If HDD is not detected for the length of time specified in this field, the hard disk
drive will be powered down while all other devices remain active.
HDD Down In Suspend (Default: Disabled)
This item determines whether the hard disk drive will be turned off during
suspend mode.
Soft-Off by PBTN (Default: Instant-Off)
This item is used to set the power down method. This function is only valid
for systems using an ATX power supply.
When "Instant-Off" is selected, press the power switch to immediately turn off
power. When "Delay 4 Sec." is selected, press and hold the power button for
four seconds to turn off power.
Intruder Detection (Default: Disabled)
This item enables or disables the features of recording the chassis intrusion
status and issuing a warning message if the chassis is once opened.
WOL (PME#) From Soft-Off (Default: Disabled)
When set to Enabled, the feature allows your system to be awakened from the
power saving modes through any event on PME (Power Management Event)
WOR (RI#) From Soft-Off (Default: Disabled)
If this item is enabled, it allows the system to resume from a software power
down or power saving mode whenever there is an incoming call to an in-
stalled fax/modem. This function needs to be supported by the relevant hard-
ware and software.
USB Resume From S3/S4 (Default: Disabled)
This item is used to set the system to wake up by USB equipment when it is
in S3/S4 mode.
MAC Resume From S4/S5 (Default: Enabled)
This item is used to set the system to wake up by MAC equipment when it is
in S4/S5 mode.
Power-On by Alarm (Default: Disabled)
This item is used to set the timing of the start-up function. In order to use this
function, the start-up password function must be cancelled and the PC power
source must not be turned off.
43