Foxconn NF4UK8AA series User Manual page 24

Front Panel Connector: FP
This motherboard includes one connector for con-
necting the front panel switch and LED indicator.
Hard Disk LED Connector (IDE_LED)
Attach the connector to the IDE_LED on the front panel of the case; the LED will
flash while the HDD is in operation.
Reset Switch (RESET)
Attach the connector to the Reset switch on the front panel of the case; the
system will restart when the switch is pressed.
Power LED Connector (PLED)
Attach the connector to the Power LED on the front panel of the case. The Power
LED indicates the power supply status. When the system is in S0 status, the
LED is on. When the system is in S1 status, the LED is blink. When the system
is in S3, S4, S5 status, the LED is off.
Power Switch Connector (PWRBTN#)
Attach the connector to the power button of the case. Pushing this switch allows
the system to be turned on and off rather than using the power supply button.
USB Connectors: F_USB 1, F_USB 2
Besides four USB ports on the rear panel, the series of motherboards also
have two 10-pin connectors on board which may connect to the front panel USB
cable to provide additional four USB ports.
NC
GND
D5+
D5-
VCC
F_USB1
IrDA Connector: IR
The IrDA infrared transmission allows your com-
puter to send and receive data via an infrared ray.
The relevant parameters for the BIOS Integrated
Peripherals should be set prior to using this
function.
16
10 9
Empty
GND
D4+
D4-
VCC
2 1
Chapter 2 Installation Instructions
IDE_LED
RESET
10 9
NC Empty
GND GND
D7+
D6+
D7-
D6-
VCC
VCC
2 1
F_USB2
1 2
PLED
PWRBTN#
Empty
NC
9 10
FP
FP!
IRTX
GND
IRRX
Empty
+5V
IR