Event: Hd Temperature - EverFocus ERS-4 Instruction Manual

3 . 8 . 2 . 2 E v e n t : H D T e m p e r a t u r e
This menu defines the reaction on critical HDD temperature.
Event
Log
Buzzer
Email Notify
Network Alarm
Stop Recording
Temp. Warning
Limit
Alarm Output
Output Type
Apply
Select HD Temperature.
Check box to record HDD temperature events in the log.
Check box to enable buzzer in case of HDD temperature events.
Check box to send email notification case of HDD temperature events.
Check box to send out a network alarm to client PC case of HDD temperature
events. (requires PowerCon software and setting up Alarm Server in Network Setup
menu)
With activated checkbox the ERS-4 will stop recording for avoiding total damage of
HDD and data loss.
NOTE: It is not recommended to deactivate this check box !
Sets the trigger temperature for all other active settings in HD Temperature. Choose
from 55°C /131°F ~ 85°C /185°F.
Note: Do not set a higher value as the max. operating temperature of the installed
HDD (specified by HDD manufacturer) !
In case of event the output relay will switch. It can be set to either "NONE" (not
active) or "1" (relay activated) .
Output type is fixed to mode:
Transparent: Alarm is active as long the event is active.
Note: It is not possible to reset this alarm without solving the HDD temperature
problem.
Save the settings for this event type.
36
ERS-4 Instruction Manual