Video Loss - EverFocus ERS-4 Instruction Manual

10.3.4 Video Loss

Camera: Select the camera you wish to adjust, "Title" will change to the title name of the selected camera.
Enable: Check box to enable Video Loss.
Log: Check box to record video loss events in the log.
Pre-alarm Record: Check box to record several moments before the video loss. (Pre-alarm recording rate
will follow "Normal" frame rate setting)
Buzzer: Check box to enable buzzer when a video loss event occurs.
Email Notify: Check box to enable email notification when a video loss event occurs.
Network Alarm: Check box to send out a network alarm to client PC when video loss occurs. (requires
PowerCon software and setting up Alarm Server in Network Setup menu)
Alarm Output: This will transmit a signal through one of the alarm outputs. It can be set to either "NONE"
(not active) or "1".
Output Type: Output action when alarm is triggered.
Timeout: Alarm output lasts for the set time duration.
Permanent: Alarm will remain active until user presses "Enter" key on front panel.
Transparent: Alarm output continues as long as there is a video loss.
Trans+Timeout: Alarm output continues until event ends, then lasts for the set time duration.
Apply To: This button can be used to copy the video loss settings to other cameras. Select which cameras
you wish to copy to. "Select All" selects all cameras, "Unselect All" deselects all cameras. Click "OK" to
copy the settings or "Cancel" to exit without copying.
Figure 10-6 Camera Menu – Video Loss
117
ERS-4 Instruction Manual