Table of Contents
Advertisement
Time Bar: The time bar uses two different colors to distinguish each recoding mode.
Off: No recording during this time block.
On: Alarm action will be recorded during this time block.
To Set Schedule using Mouse
1.
Click on desired start time block (no numbers on it) on a time bar. At this time, the selected block
will be highlighted in blue frame and the selected time bar will be highlighted by red frame.
There are 24 blocks on the time bar representing 24 hours respectively. Set a schedule start time
by clicking on a desired start time block on a time bar and clicking again to confirm it. At this time,
the selected block and all following blocks will turn gray, which means this gray time zone has been
set to the recording mode of gray (alarm action recording off).
2.
Click again to confirm, then a new number (for the new section) will show on this block and current
and all following blocks will turn to gray. This means this new gray time zone has a new record
mode (alarm action recording off).
Change the section to different mode (with different color) by clicking on the first block of each
section. The color switches from gray -> orange, every time user clicks the first block of a section.
3.
Repeat clicking on the first block (with number on it) of any time zone, this time zone will change
from one color to another, which means switching the record mode. The color switch sequence is
gray->orange.
Alarm Action Setting from front panel
1.
Enter Alarm Action setting mode: press "Enter" button to enter Alarm Action setting mode. At this
time, the whole editing area at lower-right side will be highlighted within a gray frame. See below
image.
2.
Enter camera selection mode: Use Up/Down arrow key to switch to Alarm selection mode.
135
ERS-4 Instruction Manual
Advertisement
Table of Contents
