Event - EverFocus ERS-4 Instruction Manual

10.5.2 Event

This section covers internal system event warnings.
Event: Select from the following event types.
HD Temperature: Hard drive is over the safety warning temperature
HD Failure: If ERS-4 fails to detect a HDD on start up, the system will create a HD failure event.
HD Full: If the ERS-4 is not set to Overwrite in the Record Menu, an event will be created when all
HDDs are filled.
HD Off: If HDDs are switched off or are removed, the ERS-4 will create a HD OFF event.
Power Loss: The ERS-4 keeps a record of any time the system is powered off.
NOTES: When using a contact output for this feature, make sure the control output is 5V effective.
Network Loss: If connection to network is lost, ERS-4 will create a Network Loss event.
NOTE: This function only checks physical connection to the network. Any network behaviour that blocks
connection (blocked ports, wrong IP setup, etc.) is not detected by this function.
HD Temperature:
Figure 10-9 Alarm & Event Menu – Event
121
ERS-4 Instruction Manual