Sanyo DS27820 Owner's Manual page 13

CONNECTING A SATELLITE SYSTEM AND CABLETOTHETV
1. Connect signal (cable or antenna) to the TV 75_Q (ohm) terminal O.
2. Connect Satellite S-Video Out to TV S-Video In jack.
Using the S-Video In jack overrides the Videol Input jack.
3. Connect the Satellite Audio Out (R/L) jacks to TV Audio Input (R/L) Jacks.
Press POWER key to turn on the TV. Turn on external equipment.
Cable or Antenna
IV Back system
• (See page 4.)
USING THE AUDIO OUTPUT JACKS
CONNECTING A STEREO AMPLIRERTO AUDIO OUT JACKS
1. Connect the TV Audio Output (R/L) 0 to the Stereo Amplifier In (R/L) t_.
2. Press POWER to turn on the TV. Turn on external equipment.
Note ............ '....
TVBack
Quick Tips
: [] Always
match cables
according to the
colors; ]a:D fi)r right
audio, WIIlTEfi)r l(_p
audio and YELLOW fi)r
video.
: [] Make sure all cable
connectors are .fitly
seated on the jacks.
: [] Make sure you select
TV channel m match
your V_7¢ output
(Ch. 3 or 4). See
chart on pa,qe 15.
[] l?) view two TV
programs or wat#h
a
TV program and pre-
recorded tape at the
same time, fidlow
steps on pa,qe 14.
i [] ffyou are connecting
your TV to a satellite
dish, you must
connect a cable
system or antenna
with the satellite to
use the P1P fi_ature.
: [] Position your TV at
least 2 .fi_et.fi'om
sger,oo s])#ak,ors.
The magnets in the
speakers may q_,ct
the picture qualiq.
[] Do not connect
external speakers
directly to the TV.
Needhelp?
Visitour Website at
www.sanyoclv.com
or Call 1-800-877-5032