Epson Aculaser M1200 series User Manual page 90

Status/Error/Warning
"Installed Developer Cartridge is Not a Genuine Epson Product Warning" on page 94
"Sleep mode" on page 95
"Ready" on page 95
"Printing" on page 95
"Processing Data" on page 95
Note:
If the problem remains after trying the suggestions in this section, contact your dealer or a qualified
service representative for assistance.
Service Required (controller error)
Control panel: Error light on
A controller error has been detected. Turn off the printer, wait 5 seconds and then turn it back on.
If all the lights come on again, turn off the printer, unplug the power cord, and contact a qualified
service representative.
Service Required (engine error)
Control panel: Ready and Error lights flashing
A print engine error has been detected. Turn off the printer, wait 5 seconds and then turn it back
on. If the lights come on again, turn off the printer, unplug the power cord, and contact a qualified
service representative.
Service Required (protocol error)
Control panel: Ready light flashing, Error light on
A protocol error has been detected. Turn off the printer, wait 5 seconds and then turn it back on. If
the lights come on again, turn off the printer, unplug the power cord, and contact a qualified
service representative.
EPSON AcuLaser M1200 Series
INDICATOR LIGHTS
Ready
Troubleshooting
User's Guide
Error
OFF
OFF
OFF
OFF
OFF
90