Dell Networking 7048 Release Note page 62

Summary User Impact
The following unwanted There is no effect to the switch or user, just
logs may come up on unwanted log messages on console.
console after running the
"show tech-support"
command with UDLD
and MSTP configured:
"ATP RX: Failed to
alloc" logs
On PC8100 switches, This only happens after repeated attempts at
console gets locked for adding and deleting a tunnel source and thus the
20-30 seconds if trying impact is very small to the customer.
to add a 6to4 tunnel
source within 30 seconds
of deleting another
tunnel source.
'out of mBlks' logs are There is no effect to the switch or user, just
observed on console if unwanted log messages on console.
ICMPv6 echo requests
are sent to OOB port at
line rate
Invalid characters are This only happens with this CLI command output
shown under reason and thus might be bothersome.
column for some entries
in the "show ip ospf
statistics" command.
LPI samples are not This can be confusing to the user since the switch
shown for the first time will not show the stats for the port after a new
on selecting a different unit is selected but then the stats will show up
unit number using the after going to new port and then back.
GUI.
"show fiber port optical- This field does not apply to QSFP transceivers
transceiver" command is and should display "NA" instead of zero.
showing current as zero
for QSFP transceivers.
Image uploaded with This might require the User to have to retry the
HTTP method can't be download or change the IP address or VLANs on
downloaded back to the the switch or PC.
switch if switch and PC
are located in different
networks and the
networks are very slow.
Console messages shows Our customers requested this warning to indicate
"Thermal state raised to better visibility into the Thermal settings and
WARNING" often. sensors.
Finisar LRM 10G SFP+ This specific model is not recommended for use
transceiver model – with our switches.
FTLX137D3BCL - drops
packets intermittently.
OpenManage displays OpenManage timeout warning window is
incorrect session timeout displaying the wrong value but uses the set value.
duration
Command "show fiber- Executing the command "show fiber-ports
ports optical-transceiver" optical-transceiver" with multiple transceivers
causes UI to become inserted will cause the console prompt a long
slower with multiple time to return (possibly up to 60 seconds).
transceiver count.
60
Workaround
None
Wait for 30 seconds after deleting the tunnel
source and then add a new tunnel source.
None.
The Web interface will not show these
characters.
Select a random port from the web and then re-
select the desired port to view the LPI samples.
None.
Use alternate transfer methods like TFTP, FTP,
etc.
Configure the logging level to be higher than
"Warning".
Please use the Avago 10G-BaseLRM model –
AFBR-707SDZ-D1.
None.
None.
System Firmware Version 5.1.0.1