Dell Networking 7048 Release Note page 37

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
No message The switch does not log an error message
logged for "Max when the maximum number of SSH
number of SSH sessions has been exceeded.
login sessions
exceeded" The switch does accept 5 SSH sessions
normally, when the 6th session connection
is attempted via SSH, the connection is
refused, but no error message is logged.
CLI command The CLI command "show ipv6 interface"
"show ipv6 does not paginate correctly when a large
interface" does number of interfaces/addresses are
not paginate configured.
correctly
2nd and 4th Ports report to be fiber ports and not copper
block of copper ports.
ports 5-8 and
13-16 think they
are fiber ports,
possible
problems
WebGui Secure On the WebGui under Management
Shell SSH Security,
Remote Access
Secure HTTP, Secure Shell does not work
on the Web UI
Web UI MSTP In the "MSTP Interface Settings" page of
Instance pull the Web UI, the Instance pull down menu
down menu has a range of 1-4094 MSTIs.
displays 4k
MSTIs
Flowcontrol Flowcontrol negotiation issues between
negotiation 6200 and 8024/8024F
issues with
10GBase-T
module
PC8024 - GUI - When you change the port setting, for
Under Port example the duplex settings or description,
Configuration from the GUI under switching -> Ports ->
page get error Port Configuration you will get outputs
on 10GB ports error when changing port settings on 10G
when you ports. The popup says 10G speed is invalid.
change any Error message attached. This is a problem
setting with code version 4.1.0.6 under the GUI no
problem when using the command prompt.
Unable to config Unable to configure Secure Shell from web
secure ssh from interface. Error pops up.
web interface.
error
'sshcfg_load
start' missing
pops up
Web interface The web page for iSCSI fails to open when
fails to provide selected with OpenManage.
an iSCSI web .
page when
selecting the
iSCSI item.
System Firmware Version 5.1.0.1
A Log message "Unable to
find a free connection.
Exceeded the maximum
number of allowed
connections." has been added.
Pagination mechanism
corrected.
Corrected error checking logic
to correctly select fiber ports
for fiber diags and copper ports
for copper diags.
Issue is corrected
Issue is corrected
Driver update applied.
Erroneous pop-up message
removed.
Corrected web page
Corrected web index page
All 4.2 supported
platforms
All 4.2 supported
platforms
PC8024/PC8024F
All 4.2 supported
platforms
All 4.2 supported
platforms
PC8024/PC8024F
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
Page 35