Dell Networking 7048 Release Note page 29

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
In stacking CLI output for command "show system
environment, temperature" is corrupted when
pagination is used.
"show system
temperature"
command output
is corrupted
Error message When a copper port was disabled, port was
for port enable / getting set in no negotiating mode.
disable on IE on
8024F combo
ports
Alignment The alignment issues make it difficult for
issues in the the customer to read the page.
output of "show
voice vlan
interface"
command
CLI command The displayed info is not complete on page.
"show ip igmp
snooping"
output is
truncated.
vrrp ip Switch allowed user to misconfigure VRRP
command IP
accepts invalid
IP addresses
CLI command User cannot enable isdp on range of
interfaces
"isdp enable"
does not work
for a range of
ports
"show interface The user sees the info but it looks messy
Priority-Flow- and is hard to read.
Control"
command output
is not formatted
correctly
CLI command The user would not always get the correct
"show ip route list of routes from the "show ip route"
192.168.2.2 /24" command.
not ignoring
host bits.
Port channel The members of the stack other than the
goes down master unit and their port channels, i.e. the
during master Standby units and their port channel
failover.
interfaces, are now not affected by a master
failover and the port channel stays up
during failover.
switches The switch crashes when it receives the url
rebooting - with the maximum characters.
possible crash
dump w/
emWeb
System Firmware Version 5.1.0.1
Corrected pagination in the
command handler.
Corrected by disabling
negotiation on combo ports
Corrected alignment issue
Corrected the implementation
of this command so that it
functions correctly.
Added checks to return error
when invalid VRRP IP address
is given.
Added support to "isdp enable"
command in interface range
mode
Corrected formatting issues
Corrected the logic in the
implementation of the "show
ip routes" command so that the
appropriate list of routes are
shown, depending upon which
optional parameters are given.
Corrected the logic to check
for active port channels in the
new Standby master unit.
Corrected URL length problem
All 4.2 supported
platforms
PC8024F
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
PC8024
PC8024F
PCM8024-K
All 4.2 supported
platforms
All 4.2 supported
platforms
All
Page 27