Dell Networking 7048 Release Note page 42

The CLI When executing the command terminal
command length <value>, the value is not updated
terminal length after execution.
is not setting
terminal length
value
The Service tag When executing the "show system id" is not
is being deleted showing the service tag on modular
on modular platforms.
platforms.
Release 4.1.1.9
Summary
PC7048R-RA switch has boxes
req cpu process 38-54%
utilization with single power
supply.
Router crashes on OSPF
network type change.
Occasional crash when
configuring VRRP.
Cannot create Dynamic LAG
with Interface range command
PC8024 cannot forward
packets on port9 to port16
while linked on at 100Mb.
Show fiber-ports optical-
transceiver is not displaying
the correct interface numbers.
VRRP routing instances
increased to 50.
DHCP on in-band and out of
band ports
Config commands did not
migrate correctly from version
3.1.5.13
Auto-neg option via Web UI is
not grayed out for 10Gb fiber
ports.
Simple mode, VLAN setting
not active when a port is
moved to another group
Unable to configure secure
SSH from web interface.
Secure HTTP Random
Characters
40
User Impact
PC7048R-RA switch has cpu process boxes
req running between 38-54 % utilization if
it's running either only with primary or
secondary power supply.
The switch can crash when changing the
configuration from the default of broadcast
to point-to-point.
With routing globally disabled, bouncing
VRRP on a host interface occasionally
causes a crash.
Dynamic LAG cannot be created from CLI
using interface range command.
PC8024 cannot forward packets on port9
to port16 while linked on at 100Mb.
Instead of reporting on exact ports that had
modules, diagnostics were reported on the
ports that did not have modules
VRRP routing instances increased to 50.
The warning message about IP address
conflict is not printed in case DHCP is
configured on in-band and out-band ports
and they both receive an IP address from
one subnet.
Command "spanning-tree mode mstp"
doesn't migrate correctly from version
3.1.5.13.
Auto-neg option via Web UI is not grayed
out for 10Gb fiber ports for the PCM8024-
k.
if a port is moved from one aggregation
group to other, VLAN settings are
retained but not applied until reboot.
Error message 'sshcfg_load start' missing
is returned.
Random characters populate the Secure
HTTP web page.
Terminal length settings now
take effect immediately.
The service tag was
accidentally being deleted and
is now being saved correctly.
Resolution
Corrected CPU utilization
issue when running with one
power supply.
Corrected process
synchronization problem
Correct the transition
between routing being
disabled and routing being
enabled.
Correct the command
syntax to "auto " instead of
"active"
Correct interoperability
problem between the PHY
and the switching core.
Corrected register problem
when accessing the SPF+
ports
Increased VRRP routing
instances table.
Add warning message in
case offered IP address is
conflicting with the
configured one on another
port
Correct the command tree to
migrate the old syntax.
Corrected the Web UI.
Correct initialization when
port is moved.
Corrected Web page error.
Corrected Web page data
initialization.
System Firmware Version 5.1.0.1
All 4.2 supported
platforms
All 4.2 modular platforms.
Affected
Platforms
PC7048R-RA
All Platforms
All Platforms
All Platforms
PC8024
PC8024F
PCM8024
All Platforms
All Platforms
All Platforms
PCM8024-k
PCM6220
All Platforms
All Platforms