Dell Networking 7048 Release Note page 38

Line "no The following is displayed when startup-
passive-interface config is loaded:
Vl32" in startup-
config does not Applying Global configuration, please wait
get loaded on ...
startup Applying Interface configuration, please
wait ...
******* The following lines in "startup-
config" failed:
******* Line 57:: no passive-interface
Vl32
Web GUI Switching-->Port-->Port Configuration
Admin Duplex Select a ten gigabit interface Te1/0/1 and
setting on 10G you can see that "Admin duplex" and
Fiber ports "speed" are still active and can be changed,
but when you apply it gives an error
message saying "
Error failed to set current auto negotiation
with disable".
Advertise LLDP LLDP advertises the switch's MAC address
Management as the Management Address. Request to
Address as IP advertise the management IPv4 or IPv6
Address address instead.
assigned to
OOB interface
PCM6348 - Log Messages repeated in the switch logs
message output <190> APR 28 19:39:22 10.1.208.10-1
STATSMGR[239558880]:
collector.c(1066) 3445 %% Failure in
function collectorGet
<190> APR 28 19:39:22 10.1.208.10-1
STATSMGR[239558880]: presenter.c(102)
3446 %% ERROR!! Failure in preStatsGet
0x0002011e
<188> APR 28 16:40:31 10.1.208.10-1
ARP[301140128]: ipmap_arp_api.c(855)
3325 %% Received ARP Reply on interface
Vl208 with bad target IP address
255.255.255.255. Sender IP is 10.1.209.60,
sender MAC is 76:f7:b9:cf:06:7e.
Firmware Port VLAN membership will not be shown
missing port in the GUI.
VLAN
membership in
the GUI
36
Corrected stored config
Invalid selections disabled on
page load.
The following behavior is now
implemented:
1) Will advertise service port
address if it is there
2) If service port is not there,
then will send network address
3) If both of the above are not
there and if it is routing
interface will send IP address
of the routing interface
4) If none of the above not
there, will send MAC address.
SNMP walk/gets on counters
for CPU/vlan routing ports not
supported by platform no
longer log a warning message
Web code updated to display
VLAN membership
System Firmware Version 5.1.0.1
All 4.2 supported
platforms
PCM6348
All 4.2 supported
platforms
All 4.2 supported
platforms
PCM6220