Dell Networking 7048 Release Note page 43

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
Summary
IP PIMSM BSR/RP Mapping
is not robust
Error messages when issuing a
show statistics command while
traffic running.
PCM6348 - Log message
output
Missing port VLAN
membership in the GUI.
Routing fails on VLAN.
PIM BSR join messages.
PIM-SM Not all data passed
down to the RPT.
Port Configuration page gets
errors on 10GB ports when
any setting is changed.
PIM-SM RP Fails to send
Register Stops.
IGMPv3 querier sent in error
with source address 0.0.0.0
PIM-SM Joining messages
using wrong RP address
Fails to reconfigure and
forward multicast message
DNS client error in logs and
switch locks up and needs to
be rebooted.
PIM-DM Prune states
expiring.
Email alerts do not contain log
message.
log message "internal interface
number 183 out of range" is
seen.
System Firmware Version 5.1.0.1
User Impact
When the RP or the BSR changes, the data
traffic may get affected and in some case
get software forwarded.
Accessing unsupported counters causes
error messages to be displayed.
SNMP walk through unsupported counters
cause error messages
If switch has less than 24 ports, Port
VLAN membership will not be shown in
the GUI.
Removing a VLAN routing interface
causes routing to be lost across the entire
switch.
PIM Join messages using wrong RP
Address
When network re-configuration happens,
the multicast traffic may not properly
converge thus resulting in loss of some
traffic.
Port Configuration page gets errors on
10GB ports when any setting is changed.
Register-Stop messages may not be sent
out on the correct interface through to the
First Hop Router.
Switch will get moved to non-querier
mode if an IGMP membership query
arrives with source address 0.0.0.0.
PIM-SM Joining messages using wrong
RP address
Switch fails to reconfigure and forward
multicast messages following link failure
Error message "DNS Client:
osapiSocketRecvFrom returned error for
address 0xAABBCCDD" being logged
The router might end up sending Graft
messages even though there are no
intended hosts.
Current e-mail messages display in e-mail
applications with a blank body, log
message is not displayed.
Message: "nimCheckIfNumber: internal
interface number 183 out of range" is
displayed.
Resolution
Corrected RP join
processing.
Change the logging priority
of the messages for
unsupported counters so that
they are not output.
Change the logging priority
of the messages for
unsupported counters so that
they are not output.
Corrected the VLAN port
data issue.
Corrected the VLAN
interface removal problem
Corrected Join without a
Prune condition.
Corrected Join condition.
Corrected Web page error.
Corrected Register Stops
message error.
Corrected valid address
check for membership query
packet.
Corrected Join message
processing.
Correct an RPF information
problem when link goes
down.
Corrected error in task that
handles changes of the
Service Port link status
Corrected a PIM-DM
timeout error.
Corrected error in email
header section.
Corrected error in VLAN
create web page
Affected
Platforms
All Platforms
All Platforms
All Platforms
PC70xx
PCM6220
All Platforms
All platforms
All Platforms
All Platforms
All Platforms
All Platforms
All Platforms
All Platforms
All Platforms
All Platforms
All Platforms
Page 41