Dell Networking 7048 Release Note page 24

http[s] authentication
against RADIUS only
allows privilege level 1
access
SNMP v1/2 community
manager address no longer
functions with network
address.
Switch service tag not
displayed by "show system
id" command
CLI commands are not
authorized after Password
Recovery
LINK UP on all interfaces
during POST,
FCoE -M8024-k setting
TSA map to link strict and
assigning bandwidth
allocation to TC
Switch GUI forcing 100Mb
speed on External ports
when cloning port
configurations
PowerConnect
M6348/General port GUI
issue
M6348 - service tag not
displayed in GUI
email addresses with
underscore "_" are rejected
phone port configuration
macro incomplete
Release 5.0.1.3
Summary User Impact
Re-enable Auto The Auto Negotiation can't be enabled back
on "Port Configuration->Show All" page
Negotiation
once it has been disabled.
using GUI
doesn't work
properly
22
HTTPS authentication through
RADIUS grants only read-only
access.
When a subnet IP is set as
SNMP community IP address
then snmp requests from hosts
of that subnet are not accepted
on the box.
Switch service tag not displayed
with "show system id"
command
Enabling password recovery will
not allow the user to run CLI
commands on the serial console.
Links are UP and flapping
during power reset and reloads.
In the CEE mode there is no
way to specify the TSA mode in
the ETS TLV
Switch GUI set all external ports
to 100Mb speed when cloning
port configurations.
Vlan membership information
on web is displayed and applied
incorrectly
Service tag shows up as none on
GUI
A valid email id with an
underscore cannot be used
The macro never returns and
appears to hang
parse RADIUS server response
properly
Get the mask from the
community IP address
configured and set it instead of
the hard coded value.
Added retry to get the Service
Tag value
Fixed the issue to enable
commands from serial console
also
Changed the CPLD and reset
logic
Check if any weight is
configured for the TCGs, if so
set the mode to ETS.
Corrected port speed
processing from WEB
Javascript fixed to pick correct
enum values
Synchronization issue fixed to
retry and get the tag
information
Underscore is now considered
valid character
Fixed the issue and return error
Resolution
Corrected error in Port
Configuration page.
System Firmware Version 5.1.0.1
All 5.0 supported
platforms
All 5.0 supported
platforms
M8024-k, M8024, M6348
All 5.0 supported
platforms
PC8024 and PC81xx
Platforms running DCBX
and including ETS
M6348
M6348
M6348
All 5.0 supported
platforms
All 5.0 supported
platforms
Affected Platforms
All 5.0 supported
platforms