Dell Networking 7048 Release Note page 49

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
Summary
DHCPv6 web issues
LLDP MED application should
not allow configuration of
location and inventory transmit
TLV's as underlying
application not present
SysUpTime is not being shown
correctly during an SNMP walk
(Poll interval 1sec)
Log messages need to be
corrected on ip dhcp snooping
rate limit scenario.
The show ip vlan command
output is not proper after more-
quit prompt is encountered, i.e.
after around 16 routing
interfaces
Invalid error port number
displayed on log message when
vlan is changed to forbidden
mode from access mode
The banner motd XXXXX
does not appear in show
running-config
Web page mac-vlan table too
slow to load.
Confused between ip default
gateway and ip default route
(update manual with how to set
a default route).
Auto Install show boot retry
count line needs to be left
aligned by one space.
Cannot Access Optical
Transceiver Diagnostics Page if
Multiple Submits done prior to
initial refresh completing
Error messages for non-existent
stack members non-informative
System Firmware Version 5.1.0.1
User Impact
Potential operator confusion regarding
switch configuration.
Potential operator confusion regarding
switch configuration.
Potential operator confusion regarding
switch operation.
Potential operator confusion regarding
switch configuration. Inability to diagnose
network issues.
Potential operator confusion regarding
switch configuration.
Potential operator confusion regarding
switch configuration.
Potential operator confusion regarding
switch configuration.
Potential operator frustration with switch
management.
Potential operator confusion regarding
switch configuration.
None.
Potential operator frustration with switch
management.
Potential operator confusion regarding
switch configuration.
Resolution
The acceptable character
sets are documented in the
CLI Reference guide.
Location and inventory
TLVs cannot be enabled for
transmission in LLDP MED.
The correct variable is used
to write SysUpTime
Interface representations in
log messages use unit-slot-
port format.
The paging has been
corrected.
The error message is no
longer issued.
All banner configuration
appear in the running-config
For certain browsers, paging
has been implemented to
speed up load times.
The ip default route
command is deprecated. Use
the ip default route
command to set a default
route.
The retry count alignment is
corrected
This is a browser dependent
issue (IE 6) that is not seen
in later versions. The web
session recovers after doing
a refresh.
The user can pre-configure
stack units. If the stack unit
does not exist for a switch
configuration operation, an
error message indicating
same is issued.
Affected
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
All
Platforms
PCM8024
All
Platforms
All
Platforms
All
Platforms
All
Platforms
PC70XX
Page 47