Dell Networking 7048 Release Note page 33

PowerConnect 8132/8164/8132F/8164F/8024/8024F/M8024/M8024-k/
M6220/M6348/7024/7048/7024P/7048P/7024F/7048R/7048R-RA
Release Notes
"ip http secure- ip http secure-server command not getting
server" applied when we migrate from 4.1.0.19 to
command not 4.2.1.3 release
getting migrated
from 4.1.0.19
build to 4.2.1.3
build.
Data loop in A data loop occurs in the port-aggregator if
Simple mode a new VLAN is added to an interface.
when adding
VLAN
Release 4.2.1.3
Summary User Impact
The "show fiber The "show fiber optical-transceiver"
optical- command was reporting incorrect values
transceiver" when optical transceivers that did not
command shows support diagnostics were used.
LOS even
though link is
up.
Unable to ping MTU size configured on the combo ports
with jumbo will be lost after a save and reload and also
frames set when changes the media preferences are
made.
cpCaptivePortal The description of the
WebLangCode. cpCaptivePortalConfigWebLangCode
1.1 displays en object doesn't correspond to the values it
when mib says returns.
only supported
value active (1)
LLDP When Port-Description is set as no
Assignment of description in LLDP port configuration, the
port ID for Port- TLV should contain the Port Interface name
Description as the port description by default instead of
TLV 0.
The CLI shows The "show interface advanced firmware"
incorrect media shows incorrect information under "Type"
type 10GBASE- column.
T for fiber ports
Can't assign a Config migration for the "name <vlan
name to a name>" command was not correct.
VLAN
No default route "Show ip route" commands will not display
or static route even though there were routes is in the
showing in ip router(static routes, ospf routes) for
route table terminal length 0.
System Firmware Version 5.1.0.1
Corrected command parsing
problem.
Corrected the VLAN creation
error.
Resolution
Correct diagnostics so that
diagnostics for unsupported
transceivers are not displayed.
Corrected the storing of the
MTU size
Corrected the description in
the fastpath_captive_portal.mx
file
Corrected the default Port-
Description.
Removed the Type column
which was not valid.
Corrected the config migration
for the "name <vlan name>"
command.
Corrected the display of the
"Show ip route" command.
All 4.2 supported
platforms
PCM6220
PCM6348
PCM8024
PCM8024-k
Affected Platforms
All 4.2 supported
platforms
PC72xx and PC80xx
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
Page 31