Dell Networking 7048 Release Note page 28

1. Changes are 1. Changes were not applied to the correct
not applied to interfaces on the GUI pages referred to.
the correct
interfaces on the 2. An incorrect error message was
pages displayed.
"System-
>sFlow-
>Sampler
Configuration"
"System-
>sFlow->Poll
Configuration"
2. Incorrect
error message is
displayed when
not configured
Receiver index
is applied
to interface on
"System-
>sFlow->Poll
Configuration"
page.
"show ip route The default gateway would not be shown on
configured executing "show ip route configured"
...longer-
prefixes" reports
that default
gateway is not
configured,
which is
incorrect.
CLI command The user would not always get the correct
"show ip route list of routes from the "show ip route"
command.
192.168.2.2 /24"
not ignoring
host bits.
CLI command The user could not see the configured
"show spanning- values for spanning tree max hops.
tree detail"
missing
information.
"ipv6 pim join- The user could not change the configuration
prune interval" of the IPv6 PIM join interval.
command does
not work
Macro input The interface string length is limited to 20
string does not characters for the "macro global apply"
accept more command.
than 20
characters
startup-config startup-config failed error message is
failed error displayed when finishing the Dell Easy
message is Setup Wizard
displayed when
finishing the
Dell Easy Setup
Wizard
26
1. Used initialized buffers.
2. Correct the error message.
Corrected the implementation
of this command so that it
functions correctly.
Corrected the logic in the
implementation of the "show
ip routes" command so that the
appropriate list of routes are
shown, depending upon which
optional parameters are given.
Changed the output of the
"show spanning-tree" and
"show spanning-tree detail"
commands to include the
configured value of max hops.
Corrected the implementation
of this command so that it
functions correctly.
Increased the acceptable string
length for the "macro global
apply" command to 256
characters.
Corrected the implementation
of this command so that it
functions correctly.
System Firmware Version 5.1.0.1
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms
All 4.2 supported
platforms